![]() ![]() This is because the inner circles are overlapping in the squares and are removed. When you do a Preview, you will get the following where it will only cut the welded outer squares. For example, if we have the following design with everyting set to Weld. Please note that if you have a lot of shapes set to weld, this may cause a delay when doing a Preview or before it starts to cut as the program will need to compute all the welds on the page at that time.Īlso depending on your design, the Weld option may not produce the results you are expecting. When using the Union option from the Path menu, this will combine the selected shapes into a new shape.Īfter applying the Union, if you look in the Layers tab, you will see a new single layer with the newly created shape. ![]() Now if we do a Preview, you should see what is going to get cut in Red, and you can see the parts that are ignored in gray.īecause the Weld is not altering the shapes, we can easily rearrange the overlapping shapes if we want. Select the shapes you want to weld together, and then check the Weld checkbox from the Style tab. The main difference is the Union permanently creates a new shape, while the Weld temporarily creates the new shape when you do a Preview or are actually going to cut your project.īelow is an example of using the Weld option on 2 circles. ![]() One is to use the Weld option in the Style tab, and the other is to use the Union from the Path menu. There are 2 different way to combine to shapes into a single shape in Sure Cuts A Lot & eCAL. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |